|
Xs T drill |
|
|
|
| •Description: The Xs T (thick) system can be used with any size of casing, but is predominantly designed for thick wall casing. The Xs T design has four (4) recessed portions to transfer impact directly from the driver to the crown, giving the necessary force to drill and drive down casing. The crown has a socket which fits over the casing for better welding alignment. This designed allows the driller to be able to drill the same diameter in bedrock as the casing I.D. with our special square bit, and allows the use of larger DTH hammers. •Advantages: Advantages over Eccentric systems Advantages over other Ring bit systems Advantages over wing bit systems •:Components:
Driver bit: The driver bit is the device that transfers impact and rotation to the crown bit for drilling. The driver bit locks into four flats on the casing crown and they act together as a standard drill bit, both the driver bit and the crown have tungsten carbide buttons. The Driver bit drills a pilot hole of 3" below the crown to guide the direction of the casing in rough drilling. Afterwards this pilot space below the crown allows the square bit to turn without touching the crown. Crown bit: The crown bit is a two-piece unit permanently connected together. The upper part is welded to the casing, and the lower part, which has Tungsten Carbide is free to rotate with the driver bit. Square bit: The drill through bit is specially shaped to pass through the crown's flats, and to drill the sub-casing hole to a maximum hole diameter, enabling in most of the cases, the use of a larger diameter hammer than the competition. •Impact zone: Direct energy from the hammer is transferred to the crown bit through four (4) recesses formed by the locking mechanism. •Evacuation: Two (2) big air holes are drilled in the face of the bit (drilling end). Those holes are directly connected to two (2) large flushing air ways, placed at 160 degree between each other; these flushing grooves transfer the drill debris from the drilling end of the driver up to the hammer zone. To help keeping a good flow of debris, two (2) other smaller air holes in the flushing air ways, help give the cuttings some velocity. This model also comes with a "rotational-crusher zone". That protective zone is placed at the end of the flushing air ways, just under the hammer spline drive. This zone (patent pending) is to improve the evacuation by preventing accumulation of rocks and gravel at a recess point. By turning the driver against a fix casing, the rock is crushed in smaller particles and then evacuated through the casing.
|
|
Send mail to
luc@georocfor.ca with
questions or comments about this web site.
|
